More from: TMR

TMR Imprint Custom Bike Grips

Sorry this item is currently out of stock. If you are prepared to wait until we have it in stock, we will give you an extra 10% off for the delay, just enter your email and we will be in touch:

These award winning custom mouldable grips by TMR Imprint are perfect for those cyclists looking to have complete contact with the handlebar. We have found that these grips reduce that annoying buzz felt through the fingers and that dreaded arm pump (probably from gripping too hard).

Mouldable in 5 minutes (and then remouldable if you make a mistake), getting even pressure and maximum grip is easy.

These are the Expert Version.


"We are surprised at just how good these grips feel and how well they work. We were skeptical but these genuinely have a tremendous impact on how you feel riding a bike. It’s a no brainer for us, these are keepers." - RIDE.IO

 

 

HOW TO MOULD THE GRIPS:

It's simple:

  1. Freshly boil some water and fill a glass (as big as the grip).
  2. Place another glass with cold water beside the hot water
  3. Place the mesh over the grip (leaving enough at the end to pinch / lift from the grip from the glass) and submerge for 2 minutes
  4. Lift the grip out of the glass (by the mesh) and place into the cold water for 3 to 5 seconds
  5. Place the grip on your handlebars with logo facing you, and grip as you would like it to feel. Use your other hand to flatten the rest of the mesh for an even look
  6. Remove the grip and place into the cold water for another 2 minutes to harden
  7. Replace back onto the handlebars and secure using lock ring / lock screws / end caps.
  8. Repeat for the other grip